OV Filter
    OV Filter

OV Filter

22 €
- The ignition produces approx. 20000 - 30000 volts, which means that narrow needle pulses of up to 100 volts or more can be measured on the cables. These overvoltages are often sufficient to destroy parts of the electronics after some time.
Quantity
In stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

OV Filter

The power supply in a motorbike is generally specified as 12 volts. Normally, however, the supply voltage is anything but 12 volts. In addition, the following effects occur:

  • The ignition produces approx. 20000 - 30000 volts, which means that narrow needle pulses of up to 100 volts or more can be measured on the cables. These overvoltages are often sufficient to destroy parts of the electronics after some time.
  • All inductivities in the moped generate a negative voltage the moment they are switched off. Although this voltage is only of short duration, it can reach minus 20 - 30 volts in the starter motor, for example.

The OV filter smoothes the supply voltage and short-circuits all pulses below a few microseconds to ground via a capacitor. The negative pulses are absorbed by an integrated diode.

10 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm
Input voltage range
7 - 18 Volt
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28

16 other products in the same category:

Brake 2 Flash
Quick view

Brake 2 Flash

37 €
Availability: 4 In Stock
The programming of a flasher mode is easy and will cost you about 30 seconds without the need to be a software specialist.
Skrzynka bezpiecznikowa
Quick view

Skrzynka bezpiecznikowa

125 €
Availability: 10 In Stock
Skrzynka bezpiecznikowa z 6 wyjściami zabezpieczonymi elektronicznie. 4 wyjścia ciągłe + 2 przełączane przyciskami. Ochrona przed niedoładowaniem akumulatora.
Mini Headlight Relay
Quick view

Mini Headlight Relay

44 €
Availability: 10 In Stock
You can use the module with a permanent switch if you wire the yellow cable to ground. The module works with a push button if the yellow cable is not connected. By the way, you can switch off the headlight in the button mode when you press the button for more than 2 seconds. A further press on the button switch on the headlight again.
Speedsensor
Quick view

Speedsensor

23 €
Availability: 10 In Stock
Care must be taken to ensure the correct position and alignment of the magnet during installation. The integrated LED helps to ensure correct alignment.