Air Ride Control
    Air Ride Control

Air Ride Control

95 €
- Press the button and switch on the ignition. The pump will start immediately.
Quantity
In stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Air Ride Control

This Air Ride memory unit save and recall the pump up time and the valve open time. It allow the user to save and recall individual heights of your bike. The 2 outputs can drive loads with a power of up to 350 Watt peak and 200 Watt continous. The individual height can set and store via the following procedure:

  • Press the button and switch on the ignition. The pump will start immediately.
  • Hold the button until your bike have the preferred height.
  • Release the button and press it again until the bike is in the lowest position. That's it.

The Air Ride Control switch on the pump the next time and recall the adjusted height when you switch on the ignition and it open the valve when you switch off the ignition.

10 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
5 mm
5 mm
40 mm x 25 mm x 12
40 mm x 25 mm x 12
Input voltage range
7 - 18 Volt
Maximum power peak
350 Watt
Maximum power continuous
200 Watt
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28

16 other products in the same category:

E-Harness
Quick view

E-Harness

460 €
Availability: 3 In Stock
The E-Harness contain a dashboard control module and 2 power modules what control the 12 Volt power to all lights and other 12 Volt devices in a car. All switches and buttons at the dashboard are connected to the dashboard module. The modules "talk" via a small 2-wire data line. Almost all power outputs are short circuit protected and self resetting after the short circuit.
Harness Kit
Quick view

Harness Kit

41 €
Availability: 9 In Stock
This cable kit allow you a fast and accurate build of your own bike harness. A 6 wire shielded cable allow a fast connection from the handle bar switches to your electronic box. The set comes with 30 cm shrink tube, 8 x 2 cm lettered shrink tube and 30 cable ties in 2 different sizes.
Evo Flasher 2
Quick view

Evo Flasher 2

69 €
Availability: 5 In Stock
An auto-cancel function is integrated into the module. The corresponding output flashes 4 times when a turn signal button is pressed briefly for less than 0.5 seconds and then switches off. This function can be used for overtaking. If the button is pressed for longer than 0.5 seconds, the output flashes 40 times. The auto-cancel function can be deactivated by connecting the green wire to ground.
TSM4U
Quick view

TSM4U

98 €
Availability: 3 In Stock
A short press of a turn signal button (less than 0.5 seconds) for overtaking causes the corresponding turn signal to flash 4 times. A longer press (more than 0.5 seconds) causes the corresponding turn signal to flash 40 times. This auto-cancel function can be disabled by switching on the dip switch on the pcb.