Flasher Checker
    Flasher Checker

Flasher Checker

72 €
If an indicator fails in subsequent operation, i.e. the current consumed falls below 20% of the normal operating current, the Flasher Checker activates the hazard warning function for as long as the flasher relay is activated. The hazard warning function switches off automatically when the flasher relay is deactivated.
Quantity
In stock

 
 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Flasher Checker

After replacing the original indicators with LED indicators, the flashing frequency is often increased because the current drawn by the flasher relay or BCM has been greatly reduced. The Flasher Checker is simply clamped between the flasher relay and the indicators and monitors the performance of the indicators during operation. Programming is very simple: you connect the green cable to the left indicator input and the yellow cable to the right indicator input. The device then learns the normal operating current of the indicators during the first 5 flashing cycles.

If an indicator fails in subsequent operation, i.e. the current consumed falls below 20% of the normal operating current, the Flasher Checker activates the hazard warning function for as long as the flasher relay is activated. The hazard warning function switches off automatically when the flasher relay is deactivated.

Input voltage range: 7 - 18 Volt

10 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm
Body material
ABS with 2k epoxy resin potted
Input voltage range
7 - 18 Volt
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28

16 other products in the same category:

Easy Keyless RFID
Quick view

Easy Keyless RFID

201 €
Availability: 10 In Stock
The activation of the module is made via a press on a button. Now you have 15 seconds time to put your rfid tag in front of the antenna. A red led on the antenna indicate the waiting state of the module. If the rfid tag is recognized then the led changes to blue color and the power for the bike is switching on. If the rfid tag is not recognized then the module fall back in sleep mode.
Mini Headlight Relay
Quick view

Mini Headlight Relay

44 €
Availability: 10 In Stock
You can use the module with a permanent switch if you wire the yellow cable to ground. The module works with a push button if the yellow cable is not connected. By the way, you can switch off the headlight in the button mode when you press the button for more than 2 seconds. A further press on the button switch on the headlight again.
Evo Flasher 1
Quick view

Evo Flasher 1

69 €
Availability: 10 In Stock
An auto-cancel function is integrated into the module. The corresponding output flashes 4 times when a turn signal button is pressed briefly for less than 0.5 seconds and then switches off. This function can be used for overtaking. If the button is pressed for longer than 0.5 seconds, the output flashes 40 times. The auto-cancel function can be deactivated by connecting the green wire to ground.
OV Filter
Quick view

OV Filter

22 €
Availability: 10 In Stock
- The ignition produces approx. 20000 - 30000 volts, which means that narrow needle pulses of up to 100 volts or more can be measured on the cables. These overvoltages are often sufficient to destroy parts of the electronics after some time.