Polski
Availability: Out of stock
All Cattegories
-
Motorcycle
addremove
-
Body
addremove
-
Braking system
addremove
-
Steering system
addremove
-
Drive system
addremove
-
Exhaust system
-
Used parts
-
Motogadget
addremove
-
Clothes
addremove
-
Engine parts
-
3D prints
Pol Changer
43 €
Dimensions: 38 mm x 16 mm x 11 mm
Safe shopping
Types of deliveries and payments:
[see details]
Complaints and returns:
[see details]
Guarantee safe & secure checkout
Pol Changer
Some bikes switch the outputs for the direction indicators to minus, when active. This make a change of the original indicators against aftermarket indicators a bit tricky. This polarity changer is the solution for it. It convert the ground switched signal from the bcm module or flasher relay to a positive supply voltage for the indicators. The module contains 2 separate channels. The maximum load is 60 Watt per side.
Maximum ambience temperature: 80 degree Celsius
20 Items
Data sheet
- Manufacturer
- 27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28 - Dimensions
- 38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm - Body material
- ABS with 2k epoxy resin potted
- Input voltage range
- 6 - 18 Volt
- Maximum temperature
- 80°C
80°C - Maximum output power
- 60 Watt / output
- Compatible with
- Indian bikes
- Producent
- 27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
16 other products in the same category:
Availability: 1 In Stock
Rear Horizontal Suspension BMW K100 K75 K1100 With YSS Shock Absorber Full Set Cafe Racer Retro...
1,131 €
Availability: 2 In Stock
Availability: 4 In Stock
Availability: 6 In Stock
Cyfrowa wiązka elektryczna wersja C-BS do sterowania motocyklem za pomocą przycisków i przełączników. Zawiera dwa małe moduły sterujące komunikujące się przez magistralę szeregową.
Availability: 1 In Stock
Upper Triple Tree Clamp (Yoke) BMW K1 K100 K1100 (1991-2002) RS RT LT Cafe Racer – for a 62 mm...
186 €
Availability: 2 In Stock
Availability: 9 In Stock
This cable kit allow you a fast and accurate build of your own bike harness. A 6 wire shielded cable allow a fast connection from the handle bar switches to your electronic box. The set comes with 30 cm shrink tube, 8 x 2 cm lettered shrink tube and 30 cable ties in 2 different sizes.
Availability: 10 In Stock
An auto-cancel function is integrated into the module. The corresponding output flashes 4 times when a turn signal button is pressed briefly for less than 0.5 seconds and then switches off. This function can be used for overtaking. If the button is pressed for longer than 0.5 seconds, the output flashes 40 times. The auto-cancel function can be deactivated by connecting the green wire to ground.
Front Sets – Driver’s Footrest – MODEL 1B (Long, Black) BMW K100 K75 K1100 Cafe Racer Scrambler
405 €
Availability: 6 In Stock
Upper Triple Tree Clamp (Yoke) BMW K75 K100 RS RT LT (1982-1991) Cafe Racer – for a 62mm Speedometer
186 €
Availability: 3 In Stock
Availability: 8 In Stock
Availability: 10 In Stock
- Press the button and switch on the ignition. The pump will start immediately.
Availability: 1 In Stock
Just connect the red cable to plus 12 Volt ignition, the black cable to ground / chassis, the thin input cables to the two outputs of the flasher relay in your bike and the thick output cables to your indicators. That's it.