Polski
Availability: 10 In Stock
Care must be taken to ensure the correct position and alignment of the magnet during installation. The integrated LED helps to ensure correct alignment.
All Cattegories
-
Motorcycle
addremove
-
Body
addremove
-
Braking system
addremove
-
Steering system
addremove
-
Drive system
addremove
-
Exhaust system
-
Used parts
-
Motogadget
addremove
-
Clothes
addremove
-
Engine parts
-
3D prints
Rear Light EU
108 €
The Rear Light EU is a module for bikes with emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A conversion of an US bike according to the requirements in the EU is much easier and less cost intensive with this new module.
Safe shopping
Types of deliveries and payments:
[see details]
Complaints and returns:
[see details]
Guarantee safe & secure checkout
Rear Light EU
Almost every bike what runs in US have a brake light / indicator combination in the way, that 2 lamps works as brake light and as indicator as well. This makes a conversion of an imported bike according to the requirements in the EU a bit tricky and cost intensive.
The Rear Light EU is a module for bikes with emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A conversion of an US bike according to the requirements in the EU is much easier and less cost intensive with this new module.
A brakelight dim function is activated by default. In this case is the brightness of the brakelight dimmed down to 30% if no brakeswitch is be pressed.
Maximum ambience temperature: 80 degree Celsius
10 Items
Data sheet
- Manufacturer
- 27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28 - Dimensions
- 5 mm
5 mm
5 mm
5 mm
5 mm
40 mm x 25 mm x 12
40 mm x 25 mm x 12
40 mm x 25 mm x 12
40 mm x 25 mm x 12
40 mm x 25 mm x 12 - Body material
- ABS
- Input voltage range
- 7 - 18 Volt
- Maximum temperature
- 80°C
80°C - Output power
- Max. 21 Watt / Output
- Compatible with
- Indian bikes
- Producent
- 27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
16 other products in the same category:
Availability: 1 In Stock
BLACK Upper Triple Tree Clamp (Yoke) BMW K75 K100 RS RT LT (1982-1991) Cafe Racer – Motogadget MINI
242 €
Availability: 5 In Stock
Availability: 10 In Stock
The safety module check the 2 inputs for the neutral and sidestand switch and enables the start output when the neutral switch is closed, i.e. no gear is selected. The sidestand switch is also be checked. The ignition is switched off as long as a gear is engaged and the sidestand switch is open.
Availability: Out of stock
Availability: 10 In Stock
Upper Triple Tree Clamp (Yoke) BMW K75 K100 RS RT LT (1982-1991) Cafe Racer – Full + Risers for a...
273 €
Availability: 3 In Stock
Availability: 10 In Stock
The speedometer is very easy to use: If the button is pressed and held down when the power supply is switched on, the wheel circumference appears on the display in cm and counts up between 50 cm and 220 cm until the button is released. The 4 LEDs on the outside indicate neutral, high beam, indicators and oil pressure.
Availability: 8 In Stock
Availability: 10 In Stock
As soon as an on-board voltage of 15.1 volts is exceeded for longer than 2 seconds, a warning flasher function is activated via the two blinker outputs and the additional LED output is switched on. In most cases, it is then sufficient to switch off the engine immediately to prevent major damage.
Upper Triple Tree Clamp (Yoke) BMW K1 K100 K1100 (1991-2002) RS RT LT Cafe Racer -Mini+Motosign...
242 €
Availability: 2 In Stock
Availability: 3 In Stock
The E-Harness contain a dashboard control module and 2 power modules what control the 12 Volt power to all lights and other 12 Volt devices in a car. All switches and buttons at the dashboard are connected to the dashboard module. The modules "talk" via a small 2-wire data line. Almost all power outputs are short circuit protected and self resetting after the short circuit.
Availability: 10 In Stock
You can also remove the marker light function of the BCM module if you wire the Marker Light X between BCM module and the indicators. This eliminate the marker light function of the indicators.
Availability: 10 In Stock
The reserve led for models up to 1985 is flashing when the fuel level is below 7 liter and it is continous on when the fuel level is below 4 liter. The housing is from a 3D printer and it's waterproof with epoxy glue potted.