Polski
All Cattegories
-
Motorcycle
addremove
-
Body
addremove
-
Braking system
addremove
-
Steering system
addremove
-
Drive system
addremove
-
Exhaust system
-
Used parts
-
Motogadget
addremove
-
Clothes
addremove
-
Engine parts
-
3D prints
Parts
Subcategories
There are 1327 products.
Availability: 10 In Stock
You can use the module with a permanent switch if you wire the yellow cable to ground. The module works with a push button if the yellow cable is not connected. By the way, you can switch off the headlight in the button mode when you press the button for more than 2 seconds. A further press on the button switch on the headlight again.
Availability: 2 In Stock
Dimensions: 38 mm x 16 mm x 11 mm
Availability: 10 In Stock
If an indicator fails in subsequent operation, i.e. the current consumed falls below 20% of the normal operating current, the Flasher Checker activates the hazard warning function for as long as the flasher relay is activated. The hazard warning function switches off automatically when the flasher relay is deactivated.
Availability: 1 In Stock
Just connect the red cable to plus 12 Volt ignition, the black cable to ground / chassis, the thin input cables to the two outputs of the flasher relay in your bike and the thick output cables to your indicators. That's it.
Availability: 20 In Stock
The Flasherbooster is connected between original flasher relay and your aftermarket indicators. It increase the supply voltages from the original flasher relay to 12 Volt and allow you to use your choice of aftermarket flashers at your bike. An integrated loadequalizer with 0,8 Watt load takes care for the correct flasher frequency in the most bikes.
Availability: 10 In Stock
You can also remove the marker light function of the BCM module if you wire the Marker Light X between BCM module and the indicators. This eliminate the marker light function of the indicators.
