Polski
All Cattegories
-
Motorcycle
addremove
-
Body
addremove
-
Braking system
addremove
-
Steering system
addremove
-
Drive system
addremove
-
Exhaust system
-
Used parts
-
Motogadget
addremove
-
Clothes
addremove
-
Engine parts
-
3D prints
Parts
Subcategories
There are 1327 products.
Availability: 9 In Stock
Please note that these inserts are only available for the European market.
Availability: 10 In Stock
The 4 solder pins on the rear side are connected as follow:
Availability: 10 In Stock
The reserve led for models up to 1985 is flashing when the fuel level is below 7 liter and it is continous on when the fuel level is below 4 liter. The housing is from a 3D printer and it's waterproof with epoxy glue potted.
Availability: 11 In Stock
Dimensions: 41 mm length x 26 mm wide x 12,5 mm height
Availability: 15 In Stock
Dimensions: 41 mm length x 26 mm wide x 12,5 mm height
Availability: 10 In Stock
An auto-cancel function is integrated into the module. The corresponding output flashes 4 times when a turn signal button is pressed briefly for less than 0.5 seconds and then switches off. This function can be used for overtaking. If the button is pressed for longer than 0.5 seconds, the output flashes 40 times. The auto-cancel function can be deactivated by connecting the green wire to ground.
Availability: 3 In Stock
A short press of a turn signal button (less than 0.5 seconds) for overtaking causes the corresponding turn signal to flash 4 times. A longer press (more than 0.5 seconds) causes the corresponding turn signal to flash 40 times. This auto-cancel function can be disabled by switching on the dip switch on the pcb.
Availability: 10 In Stock
The Rear Light EU is a module for bikes with emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A conversion of an US bike according to the requirements in the EU is much easier and less cost intensive with this new module.
